|
Re: Lowering gurus
This may be a bit trial/error, but from what I see on the arms....I would not purchase another set of them! If you want to keep the height, run a stock a arm/2"drop spindle. After that, you can trim the spring to fit the height that you need. Figure that 1 full coil , will be around 2 " of drop....Longhorn
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
|