Quote:
Originally Posted by dazza
Also, the manual shows 1/2 pint of oil for both the gearbox and the transfer case. The gear box filled perfectly to the correct level, but the transfer case not. I can barely see the oil which would make it about an inch low, but because I used a half pint like it said, I'm thinking it's because ours are upside down like they mentioned with the gear box. You have the same thing?
Are you planning on replacing bearings/seals?
|
Also, I forgot to add, I just drained my oil for bench test and just dumped some oil in for the test. The transfer leaked while sitting there a few days. It may have leaked from being overfilled. I noticed in the DC200 manual in the trouble shooting section, when I was perusing for parts descriptions, that overfill will cause leaks. You might dig around and verify the fill levels. I will do the same.