Re: Prototype center speaker holder
I suppose that this would make installation a little more challanging since you would not be able to use ty wraps to pull the assembly in place. I have a solution , bond 4 studs to the underside of the dash using panel adhesive. I have used a product made by Click Bond and they are fantastic. They come with a plastic application aid which sticks to the mounting surface with double sided tape and applies pressure to the bond joint.Once the adhesive is cured you remove the aid and are left with a stud which will support an elephant (providing you did the prep work properly. I am sure some of you folks are clever enough to create something similar and figure a way to hold in place while the bond cures. Finished item looks like this .Hope this helps !
|