[XwalkerX]

ok so this is how i have everything hooked up

A- 1 side of on/off toggle switch
B- 1 side of off-(on)-off momentary toggle switch
C- 1 side of off-(on)-off momentary toggle switch
D- 1 side of brake switch (12v key on but 0v pedal depressed)
E- Ground
F- 12v power supply to module with key on that runs through an inline fuse to the other side of on/off toggle (then the power pulled from toggle switch goes to middle of momentary)
G- supposed to go to other leads from brake light switch that only sends 12v when the pedal is pressed (currently this wire is reading 9/10v while not even hooked up to the leads from the brake switch)
H- n/a
J- n/a
K- bridged into wire at pin 50 on pcm


so if i take a reading at the plug with cruise plug unplugged from the box but key on i see 12v to pin F and roughly 9v to pin K (which i assumed was correct for the VSS reading but perhaps its not) and no other pins produce power.

however when i plug the connector back into the cruise module pin G produces 9/10v roughly along with those other two pins i mentioned (F+K) and since the other end of the G wire is not hooked up to anything its clearly being energized somehow from the box.

i hope that makes sense?