I did not know at the time when I sold my old wing/vent windows just like the one in the photo below that I would need some of the parts to make my new one piece windows work properly when I install them.
So to fix my problem I went over to my friends house Donnie with the '57 Chevy truck with the Jag suspension I have been posting photos of on my page.
I had to remove one of his vent windows to measure and take pictures of a part & make a card board template, I need to make for my truck. Then I went out and got some scrap metal and started the fab work and follow the directions posted by blackdiesel
http://67-72chevytrucks.com/vboard/s...=366078&page=4