The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - I seem to lack basic understanding of unplugging a plug

**dmjlambert** · 05-21-2016, 12:24 PM

Hi
I am trying to troubleshoot wiring to the brake lights. I have this connector above the gas pedal on the firewall that goes to engine compartment and from there goes to the rear of the truck. It looks like a plastic connector going into a rubber cup. I can't figure out how to unplug it. Should this be as simple as pulling the plug? I can't get it to unplug. I would like to unplug it so I can isolate the cab/dash wiring from the wiring that goes from the engine compartment to the back of the truck.

1969 Chevrolet CST/10 Pickup

Thanks
David

05-21-2016, 12:24 PM	#1
dmjlambert Senior Member Join Date: Apr 2016 Location: Cypress, TX Posts: 3,583	I seem to lack basic understanding of unplugging a plug Hi I am trying to troubleshoot wiring to the brake lights. I have this connector above the gas pedal on the firewall that goes to engine compartment and from there goes to the rear of the truck. It looks like a plastic connector going into a rubber cup. I can't figure out how to unplug it. Should this be as simple as pulling the plug? I can't get it to unplug. I would like to unplug it so I can isolate the cab/dash wiring from the wiring that goes from the engine compartment to the back of the truck. 1969 Chevrolet CST/10 Pickup Thanks David Attached Images