Thread
:
Project daily drivable 62 C20
View Single Post
09-03-2016, 06:05 PM
#
15
72cs20
Senior Member
Join Date: Jul 2014
Location: Los Gatos, Ca.
Posts: 407
Re: Project daily drivable 62 C20
Pretty much finished up the steering portion of the cross member swap. The last bit was to locate the idler arm to the frame in the right spot. I first installed the 62 idler arm and bracket just to see if it would work.
It does work but not like it really should. The idler arm pivot point location between the 62 and 72 is very close, but the 62 location will not fully allow the idler arm to copy the movement of the pitman arm. Along with that I also couldn't get the center link located where I wanted it with the 62 setup so off it came and the 72 idler arm and bracket went on as the final setup.
__________________
1966 K20 flatbed build thread -
http://www.67-72chevytrucks.com/vboa...d.php?t=768827
62 C20 build thread -
http://67-72chevytrucks.com/vboard/s...d.php?t=703583
72cs20
View Public Profile
Find More Posts by 72cs20