Made some progress this weekend. I got my taillight clearance lights working (just lots of corrosion in the plug under the bed and cleaned the connections at the lights), Lowered my front seat where it's much more comfortable, formed up a patch for the passenger floor. I used some self drilling, self tapping screws to screw it to the floor to help in the shaping process. I still need to weld the wedge piece then remove it, cut out the bad, then weld the panel in. I would like to but weld it, but I think I'm going to lap weld it since I don't have any CO2 to run smaller solid wire. I'm using inner shield wire. I played around with some of the same gauge scrap and it's a bit of a pain to but weld it.
New seat position
Patch panel
Scrap welding
I also found more work to do
Guess one of the PO's hit something, the e-brake cable is kinked also.
Broken O2 sensor
Both front axle u-joints are toast
This is stamped on my front leaf springs, I googled it but didn't find anything. Anyone know if it's factory spring markings? I'm guessing it is...
Also is it normal for the cat to be behind the muffler?
