The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**dennislbrooks** · 01-11-2017, 08:07 PM

Any suggestions of better methods are welcome. I have had the same problem with 2 left doors where the distance between the vertical pre-bends are about 3/16" too narrow.

I would like to see the vendors/makers of the half skins to not put a vertical bend in the rearward edge of the skin ---add 1/8 of an inch--- and leave it flat. Front edge, bottom edge, and indent at the top are OK.

01-11-2017, 08:07 PM	#1
dennislbrooks Senior Member Join Date: Feb 2004 Location: Williamsburg, Ohio Posts: 1,766	A novice approach to 41 door half skins Any suggestions of better methods are welcome. I have had the same problem with 2 left doors where the distance between the vertical pre-bends are about 3/16" too narrow. I would like to see the vendors/makers of the half skins to not put a vertical bend in the rearward edge of the skin ---add 1/8 of an inch--- and leave it flat. Front edge, bottom edge, and indent at the top are OK. Attached Images __________________ 1942 Chevy 1/2 ton Rod, 1959 GMC 1/2 ton Fleet Stepside, 1967 Chevy SWB K10, 1985 Corvette Coupe 4+3, 2015 Chevy Duramax reg cab 4WD W/T