Re: Side Molding Issue
They likely found out as I did, that the moulding was made to go on before the front of the truck was assembled. I was able to get the nuts on the fender right there, but it was not easy, and I was only able to get them hand tight.
Also check your moulding on the doors at the front -- there's a bolt there that is hidden behind the hinge on each side, and I could never find any way to get those on with the fender installed. Someday, I'll have to pull the fenders, and finish up the nuts in the door/fender interface area.
I'll be watching this thread to see if someone more clever than I has a secret method to accomplish this.
__________________
1972 C10 LWB, 350/350
Deconstruction began 5/2009, mostly completed restoration, 5/2017
|