So I hope I did this right.
I know it is a little crooked... I need a deeper 15/16 socket.
Lets compare: (Should have moved back 1-1/2")
Before:
After:
I also went and did some driveshaft hunting...
Found a winner!
Ends up with 2-1/2"s of "penetration." Looks good enough to me!
Now to figure out how my DShaft angles look and see if I will need shims.
Also, I need a friggin shaft for the front. I have heard to find a dshaft from a truck with 4L80e/NP241. So we shall see.
I also picked up a 02 duramax, it needs injectors and what not but seems to be a good truck. It will end up being for the business.
Also, small update on the plasma table. We are wiring it up!
Next priority is getting this truck to fire up!!!!