|
Re: LT1 GenV swap
Decided to make the fuel pump ring adapter work. Drilled the OR ring off, marked and cut the center out with a jig saw. Marked and drilled the 8 holes. Going to use fuel safe sealant between the tank and ring once I test fit the tank in the truck.
I bought this tank years ago for the 87, which has baffles for the efi... had to cut the raised section so the pump assembly would reach the bottom and be flat.
Factory o-oring
Going to use the 5/16 vent line or emissions line as the aux tank fill connection.
Dont have a solution for the stock sender yet, but shouldnt be to hard to attwch the stock level sensor to the plastic bucket.
Clint
__________________
1987 Silverado - L83 5.3 w/ 6L80e ,A/C,P/W,P/L,TILT, HID projectors, Wilwood C-10 Pro Spindles w/ 2018 silverado front brakes & C-5 Corvette Rear Disc Brakes
1999 BMW 528i - 5.7 LS1 w/ 4l60e, Ford 8.8 IRS w31 spline posi & FX-r projector retrofit
New project: 2006 BMW x5 6cyl AWD to L83 6l80e 4wd to 2WD / RWD
A poor man buy's it twice
finally got my domain name back, 87chevy.com.... site rework in progress
|