|
Re: Rat repair.
Well crap I didn't think of this, I have a right angle drill motor but no way to get the proper angle, I do have a .125 extension drill bit, I could center punch and drill through the skin and then use a spotweld drill and go through from the skin side then spot weld all the holes but I think as side from tha added work I the heat could play a little havoc on the skin.
I could use a cutoff wheel and hit the spots that way then patch in some material later.
Or just do the small skin patch and use the GEM rust killer both from inside and out and hope it creeps in to all the nooks and crannies .
This is where I wish I had more experience!
|