The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - What did you do with your truck today, Part 3

MARTINSR · 09-24-2017, 11:08 PM

I started on the drivers door to finish up the sectioning work I did 25 years ago. Well, it helps to protect that bare metal even in sunny California, because it is rusted thru! The lip at the bottom was also way too big, don't know what I was thinking when I did it but I got out a stock door I had to compare and then started making the corrections and I'll make a new patch panel too.

While the doors where there thought I would make a comparison shot with the stock and the 3.5 inch chop and 2.5 inch sectioned door.

Brian

09-24-2017, 11:08 PM	#448
MARTINSR Registered User Join Date: Dec 2000 Location: Boise, Idaho Posts: 6,003	Re: What did you do with your truck today, Part 3 I started on the drivers door to finish up the sectioning work I did 25 years ago. Well, it helps to protect that bare metal even in sunny California, because it is rusted thru! The lip at the bottom was also way too big, don't know what I was thinking when I did it but I got out a stock door I had to compare and then started making the corrections and I'll make a new patch panel too. While the doors where there thought I would make a comparison shot with the stock and the 3.5 inch chop and 2.5 inch sectioned door. Brian Attached Images __________________ 1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings"