There should have been an extra e-clip in your hardware bag
Quote:
Originally Posted by 72c5
Yes you sent me a 0.700 bore Wilwood master cylinder. It moves the slave far enough to fully disengage a brand new clutch pressure plate and flywheel.
Thanks John, your entire kit is very nicely designed and produced. Please excuse the tape on the last picture I lost one of the c-clips.
Posted via Mobile Device
|
Have you checked a transmission shop? The trans is going to have to be completely torn down to change it to a 2wd. It might be cheaper to just find a 2wd NV3500. You might inquire on the cost to change yours over to 2wd.
Quote:
Originally Posted by 68Cervd
Where would I be able to find a new tailshaft housing for my 4x4 nv3500 to make it a 2wd?
|