thanks guys. I am not a quitter
made good headway today, the trans crossmember had two slots but the mount has a single pin, so a quick slice
IMG_7408 by
Joe Doh, on Flickr
pulled the motor, was so worried about that 700lbs in the air that I didnt pay attention to the radiator, which caught on the frame as I lifted and broke the upper hose connector off. coolant everywhere. I love these carts, I bought this one and the body cart with 4k lb springs, use them all the time
IMG_7410 by
Joe Doh, on Flickr
IMG_7413 by
Joe Doh, on Flickr
hey oldman, I pulled another clamshell
IMG_7411 by
Joe Doh, on Flickr
trimmed and installed the motor mount crossmember, 10/10 would do this again. I farted around longer at home depot buying the parts for my home made mounts than I did trimming and welding this. note that its offset to the passenger side and has a 4 degree down angle
IMG_7415 by
Joe Doh, on Flickr
IMG_7418 by
Joe Doh, on Flickr
fixed the reluctant passenger turn signal on fenix
tuuuurns by
Joe Doh, on Flickr
and said goodbye!
IMG_7416 by
Joe Doh, on Flickr