Re: 1972 Blazer CST Frame off Project in NC
Next was the fuel filler neck. The ones on these 72s is not repoped, and mine had a hole in it that the PO fixed with bondo.......yeah, bondo. So, I got it welded at a radiator shop, it was super rusty so I soaked it in evaporust, then had it soaked in muriatic acid at the radiator shop, THEN sent it to Fort Worth to be electroless nickel plated. Stock was zinc, but nickel is better and easier.
Thanks to board for that vendor recommendation as well - no one in the Charlotte area would do a small job like that. And Arrow Plating was awesome - great folks to work with! I also had to make all my own gaskets for the emissions pipe and the filler neck, so I used fel-pro sheets of cork/rubber for those.
Last edited by UGAK5; 11-19-2017 at 10:52 AM.
|