we are done with all the christmas projects, did the MIL van all new steeering and suspension and found the water pump was out while in there so did that too. parties are done and visitors have gone home so it should be smooth sailing. johnboy came back today, got some more done. first we cleaned out the shop stem to stern to get the front clip inside for work, johnny worked on the studs for the cab while I clearanced for the rad and trimmed the lower section.
IMG_8100 by
Joe Doh, on Flickr
IMG_8110 by
Joe Doh, on Flickr
IMG_8101 by
Joe Doh, on Flickr
IMG_8102 by
Joe Doh, on Flickr
the 19x21 fits perfectly. right in the correct opening on the core, no need for complicated air dams on this one. (the front clip is forward about 4 inches in these pictures still)
IMG_8109 by
Joe Doh, on Flickr
IMG_8108 by
Joe Doh, on Flickr
no more c clamps holding the pedal bracket!
IMG_8107 by
Joe Doh, on Flickr
looks like the stock S10 seat will work ok, going to have the headrests removed when its recovered this week
IMG_8106 by
Joe Doh, on Flickr
got the bed pulled up to be cut down from longbed, and the s10 floor set to weld in.
IMG_8105 by
Joe Doh, on Flickr
IMG_8103 by
Joe Doh, on Flickr
should be an exciting week, ordering steering shafts tonight and dropping the seat off!