Re: Hood safety strap
Brian,
After checking out the link you provided and looking at my truck I don’t see that adapting the system to a TF would be very doable. I kinda wonder though if it would be possible to just drill a hole between adjacent parts on the stock latch and put in a pin or a padlock?
My desk lock photos above will definetl work but since I didn’t pre-install them before paint I wonder if it could be done now without damaging the finish? Drilling through painter’s tape slowly might work.
__________________
'55 Big Window Shortbed,
Drive-It-&-Work-On-It slid down the "slippery slope" to a Frame-Off Rodstoration! LQ4/4l85e/C4 IFS/Mustang 8.8 rearend w/3.73's
Dan's '55 Big Window "Build" - Well, Kinda!
|