Re: Big Bird - 1972 Longhorn K30
I think I have the back figured out. Here is a picture of the back pivot mocked up. For more support I will add a similar piece to the inside of the frame. The front is where I am hung up on. In the picture below the two half inch holes on the side almost above the factory frame cross member is where the top hinge point was located. If I was to leave it in the same location I will need to figure out how I am going to support the bottom hinge point. If I leave it in the position that I mocked up the hoist assembly in I have the cross member I made for support. I will also be adding wood or metal under the heavy angle iron.
|