The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 1970 C20 Manual Transmision Identification Help.

DEESTER157 · 04-06-2018, 12:42 PM

I do know that when I put the Bellhousing up to the transmision, the two top horizontal holes lined up but the two horizontal holes on bottom did not. Does this seem normal? And my Bellhousing has two flat spots with a little horn on both sides with vertical holes so it seems to make sense that this is where you would mount the bottom of the Bellhousing to the crossmember. Using the two top horizontal holes and the two vertical holes through the flat spot on the bottom of Bellhousing.

04-06-2018, 12:42 PM	#11
DEESTER157 Registered User Join Date: Apr 2018 Location: Fayetteville Arkansas Posts: 41	Re: 1970 C20 Manual Transmision Identification Help. I do know that when I put the Bellhousing up to the transmision, the two top horizontal holes lined up but the two horizontal holes on bottom did not. Does this seem normal? And my Bellhousing has two flat spots with a little horn on both sides with vertical holes so it seems to make sense that this is where you would mount the bottom of the Bellhousing to the crossmember. Using the two top horizontal holes and the two vertical holes through the flat spot on the bottom of Bellhousing.