I milled a steering column mount on my dad's bridgeport.
Welded in a new fender cap.
I replaced the cab steps. The rocker panels did not meet my standards.
I bent up a sample of what the rocker shape should be per the assembly manual. (compared to the reproduction piece)
So... I cut them off and made my own. That was WAY too much work without a sheet metal brake.
Next, I made the fenders fit the radius of the door. Before:
Open up the flange, and stretch out the area in the red triangle:
After:
After gapping the doors/hood/fender:
Repeat everything on the other side: