Continuing with the bench decoration, some of you may remember that we made some castings and copies at Andy Martin’s place in Oklahoma..
I had also bought some cast iron pieces while travelling.
They still needed to be cut, trimmed and processed to fit.
After
I also had 4 doorknobs.
Cut off the rear of each in order to get a flush fit drilled through them and countersunk the fronts.
Once processed, I selected some satin spray paint and got going.
While the paint was drying I also managed to sand all the holes that I filled in the morning.
Lastly, a second coat later.
Then brought to the house..
Next job is measure and fit the hardware to the bench.
.