[jwhotrod]

I must apologize, when I was grabbing photos to post, I grabbed a picture of a 32 ford chassis that a friend is building in my shop. it is a 32 Ford 3 window coupe, the body is out for paint right now. but if you look at the close up side shot of my frame you will see that the flatout engineering stuff I that I used is setup to use coil over or shockwaves instead of the mono leaf the corvette used. my plan is to use shockwaves because I am not at all fond of coilovers. No I will not lay this on the ground at a car show. If you do that, someplace at 70 mph you lose air in the suspension you wont like the results. I have built bump stops into the chassis to make sure if we loose the suspension, we can still limp to safety without damaging anything.