|
Re: AD wiring
Got a little off subject on another thread but a couple things make a lot more sense now. I installed my two terminal blocks. The 10ga wire in the kit goes from the positive side of the solenoid back into the cab. I put a terminal block in that line. A fusible link or circuit breaker needs to go in before the 10ga goes back into the cab but I'm not clear what size to get. 50 amp? 100 amp?
From that 1st block I ran a 10ga wire to the 2nd block I put on the driver side inner fender for my relays to reach. 10ga is enough since the original wire is 10ga right? I'm also not clear what size breakers I need for headlight and fan relays...
I got the starter solenoid on and I have the alternator wires almost done. Hooked up the oil pressure sender, distributor power coolant temp sender, and the electric choke wire. And I mounted the fan, just not wired yet.
|