Re: Saddle up 66 c10
A lot of research and hard work payed off. Switched my speedometer over to an electric programmable unit so I can have a functional speedometer and odometer with the t56 trans. I started by taking measurements with a caliper and printing some pieces to get the needle in the position is would have been in from the factory, next I 3d printed a small coupler to adapt the old needle to the new shaft diameter. Then I put sticker on the gauges, painted the needles and cluster housing. It turned out good so far but still have to hook power and signal to test functionality of the speedometer. I also added a tach and am really pleased with how it turned out.
|