Battled the core support quite a bit, there's not much left of it after fitting all the items up front. Ended up having to reconstruct the bottom and create a new frame for it. Would have been way easier to use the stock small big block Chevy radiator. The dodge one is so tall and the stack so thick and far forward to run the mechanical fan. The condenser is about 3/8" behind the front plastic grille.
Still need to find some heater tubes that bolt on manifold.
Finished welding the custom engine accessory brackets and painted them but then the damn clear coat lifted the base layer. I even tested it and it didn't lift in the test! So now I have to sand them down