Re: What did you do with your truck today, Part 3
Quote:
Originally Posted by mick53
Finally got to mock up my trans and order the throw out bearing. My mock up engine has a stock crank and my flywheel wont bolt to it. I was a little concerned if it would all fit together. Here's what I have.
Billet crank by Crower
Billet flywheel by Mcleod
Contour 4:1 reduction starter by Petronix
Mcleod duel disk RXT clutch
Ordered Mcleod hydraulic throw out bearing.
Ordered Wilwood remote res. clutch master cylinder. My brakes are Wilwood.
American Power train aluminum bell housing. Rated the same as steel.
Tremec TKO 600 5 speed
Everything fit perfectly. I'm not torquing anything down just checking fitment. It was a fine day in the shop.
|
are you doing a build thread on your motor build? I love straight motors.
|