Re: 1968 GMC - Ol' Blue
I have one, just haven't installed it yet. My engine came with the harness that goes from the TAC module to the gas pedal and it had a grommet on it which was huge for such a small bundle of wire. So I cut the middle out of it and also cut it in one spot so I could get it in place after pulling the wires through the hump. It turned out to be the perfect diameter after cutting the middle out.
And yes, if the floor was cheaper, I may have gone for it. The only mistake I made was not paying close enough attention in mocking up my driver side outer rocker. The inner floor section ended up further outboard than it should have, so the inner lip of the outer rocker and that ridge in the outer floor come pretty close and it made it hard to install weatherstrip and I'll probably have to trim the sill plate to make it lay down. Hopefully yours came out better than mine!
|