The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 1968 GMC

**Jason Banks** · 10-31-2019, 01:24 PM

I screwed up the outer floor on the drivers side even though it was the second one I did.

I ended up with the other floor too far in where the rocker and cab corner wouldn't meet up to it.

I discovered it early and was able to cut it out, but had to add a thin 1/8 - 1/2 inch tapered strip of metal back in. Which meant I had to do twice much welding and grinding.

Do you have a part number for the grommet you are going to use? I haven't really looked for one yet. I was hoping I could cut a 'notch' in the back edge of the hump, so the hump could be removed/installed with the wiring still in place.

10-31-2019, 01:24 PM	#127
Jason Banks Senior Member Join Date: Dec 1999 Location: TX Posts: 1,529	Re: 1968 GMC - Ol' Blue I screwed up the outer floor on the drivers side even though it was the second one I did. I ended up with the other floor too far in where the rocker and cab corner wouldn't meet up to it. I discovered it early and was able to cut it out, but had to add a thin 1/8 - 1/2 inch tapered strip of metal back in. Which meant I had to do twice much welding and grinding. Do you have a part number for the grommet you are going to use? I haven't really looked for one yet. I was hoping I could cut a 'notch' in the back edge of the hump, so the hump could be removed/installed with the wiring still in place.