|
Re: Distributor block off plate for a 292
I am assuming that you aren't using an oil pump driven by the cam that has to be driven by the distributor shaft?
You are probably going to end up having a local job shop machine shop turn one out of a piece of round stock unless you have access to a lathe or a buddy with a lathe.
It's a simple basic lathe job if they have the distributor to measure from.
There are so few guys doing the setup you are that there is no market for producing a plug.
On the other hand you might get by with the right size cup plug.
__________________
Founding member of the too many projects, too little time and money club.
My ongoing truck projects:
48 Chev 3100 that will run a 292 Six.
71 GMC 2500 that is getting a Cad 500 transplant.
77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around.
|