The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**1971Stepside** · 02-10-2020, 10:24 AM

Didn't get a lot of shop time this weekend. I am working on cleaning up a lot of little projects that need to be done on the build. One of them is the support bracket for the cold air intake. I have a bad habit of leaning over the front of the truck and laying my arm on the intake and it slowly sinks down. So, I made this bracket that uses the factory holes on the alt bracket tower. Turned out pretty clean.

02-10-2020, 10:24 AM	#302
1971Stepside Almost Satisfied Join Date: Mar 2002 Location: Springfield, MO Posts: 2,932	Re: 1971 Stepside LS Build Didn't get a lot of shop time this weekend. I am working on cleaning up a lot of little projects that need to be done on the build. One of them is the support bracket for the cold air intake. I have a bad habit of leaning over the front of the truck and laying my arm on the intake and it slowly sinks down. So, I made this bracket that uses the factory holes on the alt bracket tower. Turned out pretty clean. Attached Images __________________ 1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far."