[goatless]

Originally Posted by SCOTI

But..... How much drop are you intending to have since your plan is to 'bag' the truck?

If you drive it low (more than a typical static coil w/block drop) & need the wheel opening lip trimmed to ensure clearance, the seam between the upper/lower bed half is @ the same dimension. You can't just roll it for clearance so it becomes more work required.

Like I stated about earlier responses, what might work for one truck might not for another based on what parts are used & how low/what the owner considers low. Based on the trucks I've done, this truck has a very mild drop & not what I would consider a 'bagged' ride.

I went and installed long-tube headers recently, so it's not going to get any lower for now.