[Jemezcrusher]

Good solution to the same problem I am having with my Altman latches. I think they need a bit more adjustability. My “pins” are too high when the door is perfectly aligned. I think it needs to come down 1/8 to 3/16. I considered taking some material off of the bottom of the two little thread bars that go in to the area behind the plate letting the plate go down a little. If that does not give me enough movement down I will look at your solution. I guess I can look at current fitment and figure out how much it needs to go down, swap them side to side and put new holes in. Thanks for the tip