Quote:
Originally Posted by LockDoc
-
Copied from the H.A.M.B.
... It WILL fail and peel if used on surfaces other than the inside flanges in a pinch weld...
That said, I use it in both modern collision and restoration, but only where its "pinched" between two pieces of steel...
LockDoc
|
Would you consider welding on angle iron that runs the length of a 1954 truck bed on either side at the bottom just above the wood planks a pinch weld? I plan on drilling holes in my angle iron every 6 inches then mimicking spot welds (aka rosettes) in those holes to the bed sides using my MIG. I plan on using weld through primer on the back of each angle iron and along that line on either bed side.