|
Re: Squaring up and aligning PB Frame ?
My 64's set-up is PF front x-member, LWB-to-SWB frame chop, & rear frame 'Z'. Not exactly apple-to-apples but in the same spirit...
I did diagonal measurements based off of factory holes on each rail/side. I did diagonal measurements from:
Front rail ends to rear rail ends
Front rail ends to back cab mounts
From back cab mounts to rear rail ends
The frames weren't perfect from the manufacturer (mine was off <1/8" when measured as a LWB). I was able to get within 1/16" diagonally once modified.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|