Sometimes I wonder if there is something wrong with me. So I was having problems with clearance with the radiator fan motor being to close to the oil fill neck on the cummins. I don't know how I did not think of this sooner. I lossend the brackets I made and slid the fan over a little bit. I only had to make one new bracket and do a little trimming to clear the upper water neck. Now I have just enough room between the fan motor and oil fill neck. Then I scooted the cab back as far as I could I have about 3/16 of clearance between the wastegate and the heater box now.
I also installed the hood today.
IMAG2950 by
jarrod vanwinkle, on Flickr
IMAG2949 by
jarrod vanwinkle, on Flickr
IMAG2952 by
jarrod vanwinkle, on Flickr
IMAG2951 by
jarrod vanwinkle, on Flickr
under hood clearance
IMAG2953 by
jarrod vanwinkle, on Flickr
IMAG2954 by
jarrod vanwinkle, on Flickr
I have about an inch between the hood and cap in the brake fluid reservoir.
IMAG2955 by
jarrod vanwinkle, on Flickr
I just realised I never took a pic of the cab dollies I made I used 4 scissor jacks and two furniture dollies and some wood bracing. I used them to remove and install the cab on the frame. I use them to adjust the cab on the frame.
IMAG2956 by
jarrod vanwinkle, on Flickr
IMAG2957 by
jarrod vanwinkle, on Flickr