No new updates on the truck, still waiting on a new inner tie rod, then I can get it aligned.
I did do a design/print for a fellow board member who is adapting a new style mirror to the stock mounting hardware. I plan to do a similar mirror in mine, so the project was a little self-serving too.
Our mirrors came with a ball/stud that is a narrower diameter than what modern mirrors use. So I redesigned the ball/stud with a bigger ball, and then included a wiring tunnel. TA_C10 did a manual mod to his ball/stud to help setup what the design should be.
Then I printed it in nylon/carbon at about 50% infill (meaning it's half air inside). Now it's off to TA_C10 to test out!
