|
Re: HELP!!! upper/lower control arm info needed
Quote:
Originally Posted by Big Kev-O
Bringing back an old thread because I have some questions regarding the spherical washers seen in the pictures. Do they serve a purpose or can i use regular washers?
The 71-72 cross shafts are flat, unlike my original 68 shaft which curved and used a washer that was flat on one side and curved on the other. So can I just use some regular washers and let the alignment guy add shims as needed?
Thank you!
|
They are beveled on one side & flat on the other so they'll seat up against the cone shaped spacer that's on the upper stud.
On some trucks, the spacers are flat on both sides. You need them if you have the cone shaped washer (spacers) on the studs.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|