Spindle Tie Rod End Inserts
I recently purchased CPP modular spindles to use w/an older Dropmember. The Dropmember requires the TRE hole on the steering knuckle to be drilled out to allow a bolt in heim-joint as the TRE. The problem is the CPP knuckles TRE hole is already too large (the minor end of the taper is the size of the bolt).
I googled 'TRE inserts/spindle steering inserts' but all I'm finding is tapered inserts for 4x4 guys flipping/converting to 3/4-ton/1-ton GM TRE's for additional clearance.
Anyone know of a source for non-tapered 'repair' inserts? The heim through-bolt is .625".
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 08-11-2020 at 01:31 PM.
|