Quote:
Originally Posted by Palf70Step
Glad you sourced that out
|
Absolutely.
Once one knows what it is, it becomes easier.
Also got directions on how to dismantle them, it involves boiling water to get the edge trim softened before e you peel it off carefully.
It’s like a ring around the edge.
Made up a small chassis number plate to add to the fibreglass body this week.
I will screw it inside the glovebox in the end.
The chassis number is on the chassis leg as expected, but not very well accessible.
I wondered if it will be visible once the motor is back in, and it has been painted in under seal.
Nice to have the right tools.
Thanks Bootfair.
Need to get the RX8 seats out of the C10 cab in the garage to start removing all the motors to lighten the drivers side up.
Also need to find out if MX5 rails can be used on them.