The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed

88Stanger · 10-24-2020, 09:34 AM

Question: How or what tool do you use to cut straight lines on exhaust or round pipe? Specifically when you are needing to make some slight bends in straight pipe, you can cut slight angles in the cut then spin one of the pipes just slightly to start the pipe in a new direction with a little bend? Thanks guys.

10-24-2020, 09:34 AM	#321
88Stanger Registered User Join Date: Mar 2015 Location: Washington State Posts: 1,644	Re: Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed Question: How or what tool do you use to cut straight lines on exhaust or round pipe? Specifically when you are needing to make some slight bends in straight pipe, you can cut slight angles in the cut then spin one of the pipes just slightly to start the pipe in a new direction with a little bend? Thanks guys.