|
Re: Wiper Motor Install (Grommets, Seals, Timing Marks)
Hi Leon, thank you for mentioning a jumper wire from washer pump screws - I had that in my mind too as an option. So I guess that would be "Plan B".
Well, GMCPaul's grommets are not sold as a set but as "each" and the photo they provide on their site does not show a groundling arm. My grommets, firewall seal, and shaft seal show up today from them. I'll be posting on what I got soon enough but I wanted to hit the ground running on installing the wiper motor.
As for priming the OEM Washer Pump, I don't need to do that anymore as I am now using a aftermarket Jug/Pump combo in the engine bay.
__________________
Richard
'72 Chevy C10 Cheyenne *Super WHT/MED BRONZE/WHT
SBC 350 | TH350 | LWB | AC | Buddy Seats
Upgrades: Tilt | Front Sway Bar | Radio | Sliding Window | Bed Spare w/Lock
Bed Rails | Full LEDs | Courtesy Lights | Tachometer | Glovebox Lock & Light | Head Light Relays | *Upgraded Fully Super Trim
Last edited by Rich72C10; 01-02-2021 at 12:18 PM.
|