More transfer case fun!
I painted a few more parts overnight. Installed the front output cover and yoke, and the serial tag.
Also installed the PTO cover plate.
Then the rear output gear assembly.
I had to make my own gaskets out of an extra one, because these weren’t included.
Detents and plugs installed!
Installed the rear output extension housing.
Along with the seal housing and speedometer drive components.
Rear output yoke installed!
Shift linkage installed, it’s complete!
Prepping the gasket surfaces with some sealant for install.
About ready to roll this thing into me and bench press it into place!
After a few choice words and a little bit of struggling with turning the input shaft and holding the transfer case from crushing me with just one arm, it’s installed!