Alright, not a super big update this weekend as I had a few other major things going on. One, was picking up a new truck! 2012 Silverado LTZ, 1 owner, 106k miles for $5k under book.
More parts! Exhaust clamps, door switches, and the wire for the starter switch.
This is what I’m starting with to make the starter jumper.
Cut down to a single plug.
Jumper made!
Door switches installed. These were the biggest pain in the ass to run the wires down to! 0/10 do not ever replace
I also made part of the jumper that will supply the Holley harness with +12v switched from the ignition wire on the engine harness, and also disconnect the fuel pump wire.
I started on the clutch reservoir bracket. It had to be mounted on the side due to the older style hood hinges interfering.
New mount bent up and fitted.
Added some side support to it.
And painted!
I also made a close off plate for the original clutch rod hole.