Re: 67 SWB First Build
After wet sanding everything I went through and sprayed another coat of 2k urethane primer. I’ve started up in the sanding again after i let it cure for a bit. Mainly been working in the evenings for an hour here and there.
The cab is looking pretty good. I went through and marked it up with some tape to fill in all the small little pin holes i missed earlier. Also hit a couple spots with seam sealer that i had missed and then the are a few spots that need a small spot prime and sand to get right.
I hope to finish up the sanding in the near future so I can move everything out of the shop and to a potential bodyshop to cleanup anything i missed and to get paint rolling. Looking forward to putting this step of the project behind me.
Pictures aren’t anything special, but nothing exciting has really happened haha.
|