The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Rich72C10** · 05-23-2021, 02:22 PM

I am a glutton for punishment...

I decided to check all the screws, nearly all but two were loose. The bottle two being the worst, one was 2 1/2 turns loose before getting to snug. Though it is still whistling. I spray carb cleaner (which scared me) all around the carb (under the air horn). No change in anything, the whistling or RMPs. So I don't know what that means but I am sure it means something...

Though she did drive a bit better after snuging down the screws but still stumbly taking off / low end :'( Its a real shame, since if I give her good pedal / WOT I'm moving fast!

05-23-2021, 02:22 PM	#148
Rich72C10 Mr. Cheyenne Join Date: Jun 2020 Location: Kyle, Texas Posts: 1,644	Re: Hard Starting Hot I am a glutton for punishment... I decided to check all the screws, nearly all but two were loose. The bottle two being the worst, one was 2 1/2 turns loose before getting to snug. Though it is still whistling. I spray carb cleaner (which scared me) all around the carb (under the air horn). No change in anything, the whistling or RMPs. So I don't know what that means but I am sure it means something... Though she did drive a bit better after snuging down the screws but still stumbly taking off / low end :'( Its a real shame, since if I give her good pedal / WOT I'm moving fast! __________________ Richard *'72 Chevy C10 Cheyenne Super WHT/MED BRONZE/WHT SBC 350 \| TH350 \| LWB \| AC \| Buddy Seats Upgrades:** Tilt \| Front Sway Bar \| Radio \| Sliding Window \| Bed Spare w/Lock Bed Rails \| Full LEDs \| Courtesy Lights \| Tachometer \| Glovebox Lock & Light \| Head Light Relays \| *Upgraded Fully Super Trim