The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - What did you do with your truck today, Part 3

MARTINSR · 06-06-2021, 09:34 PM

Ok, so I got my five minutes in today! I aligned the front end over at the rad support/frame to then align the hood back a hair on the right side to near perfection. I using a piece of tape marked off the rear and trimmed off the spot that was too long and so I will know how much to lengthen it in the center. I am going to use the strips of metal I cut off the sides to widen the middle.
As as I am posting this I realized that I will likely be moving those pieces a hair before welding them on permanently and that will likely change how much I should have trimmed off them, CRAP! Ok, at least I got something done. LOL

Brian

06-06-2021, 09:34 PM	#4903
MARTINSR Registered User Join Date: Dec 2000 Location: Boise, Idaho Posts: 6,003	Re: What did you do with your truck today, Part 3 Ok, so I got my five minutes in today! I aligned the front end over at the rad support/frame to then align the hood back a hair on the right side to near perfection. I using a piece of tape marked off the rear and trimmed off the spot that was too long and so I will know how much to lengthen it in the center. I am going to use the strips of metal I cut off the sides to widen the middle. As as I am posting this I realized that I will likely be moving those pieces a hair before welding them on permanently and that will likely change how much I should have trimmed off them, CRAP! Ok, at least I got something done. LOL Brian Attached Images __________________ 1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings"