Quote:
Originally Posted by 6DoF
it's a Branik pc that i had them customize. i sent them a used CV yoke off the front of a ram 241 to machine vs a standard yoke on one side. got the yoke from TorqueKing. the same yoke is interchangeable with the ram's 1350 or 1410 CV drive shafts.
http://branikmotorsports.com/branik-...-bearing-1410/
https://torqueking.com/product/99108...1dhd-np241dld/
my YJ was built with the same CV shaft front/rear with a 2pc front. but a WAY cheaper junkyard build. i took the front output shaft from a roached NP231, radially cut the gear off, and turning ground whole thing to 1.5". just the seal dia the whole shaft back. that slipped into some 1.75" x 0.120 wall DOM leaving half the shaft exposed. i then slipped a cheap pillow block onto that remaining 1.5" OD and mounted that to the frame. the stock 231 1310 CV yoke will bolt on/off. nice and rebuildable with basic bits. a stock TJ slip yoke also uses a 1.5" seal so it slipped into the other end of the DOM to complete the mid shaft and go to the d300 with a standard joint.
only issue is the angles aren't set up right and will vibrate bad at speed if i don't unlock the hubs. the 55 however has precisely set angles 
 |
Nice... That is what I was planning. A Junk Yard solution. I'm all about that.