Quote:
Originally Posted by TA_C10
Looking great man. Normally for oil canning you would shrink the metal to tighten it up but if it's low then hmmm, that would make it lower right? Interested to see how you tackle this one.
|
I have used the heat shrink technique before. Definitely an amateur at it, but it has worked to eliminate oil canning. I want to explore other options first though - I don't want to make it worse. If I could figure out a way to push up the metal and hold it in place permanently, I would be happy.
Quote:
Originally Posted by sfont66
Again, nice work, and great progress. at the rate you are going you will be driving it before winter comes!
Will this become your wife's truck? So much hard work put into it, i would hate to see you sell it now!
The recent photos certainly show that you have a good size shop to work in, well equipped too.
Keep up the good work, your progress is very motivating to the rest of us.
|
No, not a truck for the wife or for us to keep. Just a project for us - I'm sure we'll find someone that will enjoy it. But yes, the goal is to have it done this fall. It's my dad's shop and it's been such a great place to work on various projects over the years.